kent spaulding
spauldo
Pictures?
68 cuda project pics
- Thread starter kent spaulding
- Start date
-
PapstXX
Well-Known Member
Sweet high five brother for good work 
bjkadron
Well-Known Member
Nice! But you can't show us a engine in a dyno cell and not tell us more..
cudaspaz
Well-Known Member
Looking like you're ready to drop that chassis on a nice chunk of change.
Yes, please tell about the build.
Is that the MSD digital e curve dizzy?
Yes, please tell about the build.
Is that the MSD digital e curve dizzy?
kent spaulding
spauldo
The motor is a 340 Resto block 4 bolt main that has been stroked to 410 cu. inches. It made max. TQ of 496.1 @4500 RPM and max. HP of 474.9 @ 5600 RPM. That's a Control Freak IFS system that it rests on with a Tremec TKO 5 speed transmission and I will be running a Caltrac mono leaf supension with my 8 3/4" and 3:91 gears. The intake is a Eddie Air Gap with a Holley #770 Street Avenger that is running 72 front jets and 75 rears. This is a pump gas motor, I was going to mess around with some race fuel but asked myself why?
kent spaulding
spauldo
the lower quarter patch panel was taken off a Ford F-150 hood and massaged a bit to make the patch.
unknownsnake
Well-Known Member
nice nice
Now THAT's some work Kent! Be proud of your efforts. Did a double take on a couple of your pictures (almost a twin to my car back in the day). Welcome to the best Mopar site there is ... you're gonna fit in perfectly around here. :-D
kent spaulding
spauldo
I,ve owned 5 of these fastbacks in the past 10 years but only 3 of them were worth restoring. The one in the photo was delivered to me from AZ and the interior was COOKED but rust issues were minimal. I know the mopar purist would freak with all the aftermarket goodies I put into this car but I'm building it for myself. Thanks for the support young lady...
Purists would hate mine too. :-D You're a guy after my own heart! Keep it up and keep us posted on your progress. I don't have much in the way of leftovers but hit me up if you run into a problem find.
Mr Man
Well-Known Member
Nice! That's my kind of build... What kind of clutch are you using? And are you using a hydraulic or mechanical clutch linkage?
Thanks for sharing!
Scott
Thanks for sharing!
Scott
kent spaulding
spauldo
Kessler set me up with a mechanical clutch 10.75" Sachs I believe.
Nite Moves
Well-Known Member
:cheers:Man from what i see ....that is going to be a greta looking, performing ride..............Nice very nice
-
Similar threads
