[SOLD] 71 340 shortblock (stroker)

[junior636]

January/71 date coded 340 block, all machine work done, deck sqared, line honed, bored 4.100", main girdle. New in box Diamond turbo/blower pistons (10.1 comp). New in box Eagle rods with L19 bolts, New billet BME crank, 340 mains 2.100 sbc rod journals all balanced and ready for assembly set up for 378ci. All Clevite Bearings and Total seal file fit rings.

Selling apart for $3800, or assembled for $4500

If you have any questions pm me. If you want the motor assembled it will be assembled by Great Lakes Racecraft. If I do not get any interest I may just have it put together. I am only selling due to going to a big block instead. I am near Grand Rapids, MI.

 

[junior636]

 

[junior636]

Need to move this, make me an offer, i would take $3,000 un assembled. The crank alone was $1,500, willing to ship.

 

[pishta]

Junior, those pistons say flat top but also say -21.5 cc , they are 10:1? That seems high for a turbo/blower piston.

 

[junior636]

Not looking to give this away but am willing to entertain offers, I have over $4,000 into this short block!

 

[swinger340]

Were cylinders sonic checked? Most 340 blocks I have seen are pretty thin by the time they get to 4.1"

 

[junior636]

Need $ for my build $2000

 

[oldkimmer]

/..........................p/m sent...............kim...........

 

[gkmopar]

PM sent

 

[bandman1971]

3rd in line. PM sent

 

[junior636]

 

[junior636]

I can get better pics of the block upon request, these are just pics my engine builder sent me. All the parts are at his shop so i will have to go there and get pics if needed.

 

[chrisnben]

dibs per PM, etc.

 

[junior636]

Deal pending with Chrisnben, block is getting sonic checked tomorrow morning.

 

[junior636]

Sonic check was good, cylinder bores still have .21-.285 thickness. Replied to all pms, I'm not waiting around for people to make up there minds, first one with cash or decent deposit. Let me know.

 

[mrhotrod]

where you located?

 

[junior636]

Grand Rapids, MI

 

[junior636]

After going over parts with an interested buyer we discovered that the rod pin diameter and the piston pin diameter were different. Probably just going to part this out now. I will start a new thread for each of those items. Sorry to anyone who was interested, this set up would still work but would require a custom cut piston and pin. I was not aware of the issue until we started going through parts, everything was still new and in the packages. Mods can delete this thread if you wish.

 

[crackedback]

The crank is a 3.58"?