I'm trying to route cooler lines from my tranny to the radiator. Is there a port on the passenger side of a 727 I can use? There is a line pressure port between the front and rear servo but not sure if that's an ideal location. ?? The typical pressure port in front of the shift lever is cluttered with TTI headers and after market shifter cable.
727 Pressure port
- Thread starter chargd72
- Start date
-
68 Notchback
Member
Don't know the answer to your question but the folks at A and A Transmissions specialize in the 727 and 904 trans. They've been very helpful on my projects. Try them out: Home - A&A Transmissions
TrailBeast
AKA Mopars4us on Youtube
You can't use a pressure test port for a cooler line without loosing the pressure to parts than need it.
Just get in there and deal with it like the rest of us had to do.
Just get in there and deal with it like the rest of us had to do.
You can't use a pressure test port for a cooler line without loosing the pressure to parts than need it.
Just get in there and deal with it like the rest of us had to do.
Well, damn. Ok.
TrailBeast
AKA Mopars4us on Youtube
I know.
I swapped mine over to 3/8 lines and all larger fittings with the cable bracket and headers in the way.
Taking the bracket off on my car makes me readjust sometimes 3-4 times before it's back right where I want it.
TrailBeast
AKA Mopars4us on Youtube
fishy68
Tyr Fryr's Inc.
Unless you drilled out the case and retapped it to use larger fittings you won't get any more flow because the port hole size in the case isn't nearly big enough to take advantage of the -8 line size
-
Similar threads
