......which is the best 1 and where would I buy it..........need the pass side inlet........thanks......kim...
Don't have one but I notice they sell in clearance for 50. Says you can "open them up". Worth the difference?Anyone with the source 1 got any comments.
Kim: I bought an alum. water pump housing from 440 source or off ebay, cant remember. But I compared it to the stock 1967 housing that was on my engine when I bought it. the interior holes were very close to being the same. But I WORKED THE INTERIOR HOLES A LITTLE, AND WHERE IT MEETS THE BLOCK, NO PROBLEMS SO FAR. ( FAT FINGURES! )I seen that but has anyone actually ported 1 out and been happy. Kim
Well, I bought one of those housings from 440 source, ported it as best I could and it still overheated. The problem with porting the pass side inlet housing is that you can't get the burr where you need it even with a 6" burr so you can't open up the ports.I seen that but has anyone actually ported 1 out and been happy. Kim
I didn`t have any trouble duplicating the original housing, the alum. housing was very close tho !Thanks for the comments guys. I'll bite the bullet and get a new source 1. Kim