Are stroker cranks drilled for input shafts??????????

[duster360]

This is for future reference. Can someone tell me if the aftermarket stroker crankshafts are drilled for manual transmission input shafts? If not, is the metal good enough ( porosity issues) to drill for a pilot bushing or should a later model bearing be used and the input shaft be shortened?

 

[physixx]

Every one that I dealt with was drilled.

Ken

 

[philcollins]

My Scat scrank was drilled.

 

[jbc426]

This is for future reference. Can someone tell me if the aftermarket stroker crankshafts are drilled for manual transmission input shafts? If not, is the metal good enough ( porosity issues) to drill for a pilot bushing or should a later model bearing be used and the input shaft be shortened?

Mine have been drilled for either bushing or bearing.

If you are using a scatter shield, make sure your trans slides all the way in without binding in the last 1/2" before seating and check that the mating surface is both square to the back of the block and the hole is lined up to the crank centerline.

 

[duster360]

That's what I was hoping to hear. JBC426,I do have a scatter shield and thanks for the tip.