port-holio
Well-Known Member
Comp 918 blue stripe beehive springs used with a Hughes hyrdraulic street roller on ported Edelbrock LA RPM heads. Took a little head scratching, but not too tough, since the heads are set up with 2.02"/1.60" Chevy tall race valves from Eddy.
I've been meaning to post this for some time and finally got around to it. Engine was built for sleeper torque with a Hughes 218/228 @ 0.050", 112 split, 0.565" lift hydraulic roller. Rocker set is Hughes 1.65 roller rockers.
In a 3400# w/ driver Duster, ran 12.76 @ 106.5 with a 2.76 ring gear. Idles about 600rpm with just a little chop. Cruises at 85mph at about 2900rpm with a 727.
PH
I've been meaning to post this for some time and finally got around to it. Engine was built for sleeper torque with a Hughes 218/228 @ 0.050", 112 split, 0.565" lift hydraulic roller. Rocker set is Hughes 1.65 roller rockers.
In a 3400# w/ driver Duster, ran 12.76 @ 106.5 with a 2.76 ring gear. Idles about 600rpm with just a little chop. Cruises at 85mph at about 2900rpm with a 727.
PH