cart

[Mopar Al]

Anybody have pics, or plans of a dolly, cart that they used to install motor, trans together from the bottom? Going in 73 Swinger.

 

[64DartGTinAZ]

Here's one I posted a while back - and then everyone bitched that they could weld one up cheaper, etc. ;-)

http://store.uscartool.com/Mopar-K-Frame-Stand-Drivetrain-Restoration-Tool_p_84.html

Disclaimers:
I have no stake in US Car Tool making money off of this
I could weld my own
I haven't fab'd my own
If you don't have a welder, etc. already, it would be cheaper to buy it than to buy a welder, etc. so you could save money fab'ing your own
I don't need one
I haven't bought one
There are pictures of something like what you asked about

 

[Mrpatel]

Looks good to me, I would consider doing it this way if and when I need to pull my motor again. Money well spent pulling a BB out of an A-Body with headers. Andrew

 

[zkx14]

Here's what I came up with from metal I had laying around. Worked pretty good. Would have been better if a little shorter/ wheels moved back. Was tight fit for legs of hoist. Also, was a bit of a challenge to get engine from this to engine stand and back.

http://www.forabodiesonly.com/mopar/showpost.php?p=1969998385&postcount=34

 

[clifftt]

I sat mine down on two of Harbor Freight's $9.00 wooden coasters. It was a little awkward getting the casters to roll in the same direction, but it worked and it was cheep!

 

[Ben Drinkin]

I just droppped it down on one of these. Slid right out. A whole lot easier than I was expecting..