AlV
Crabs in a barrel
Anyone have a torsion bar removal tool I can borrow?
I want to swap in a set of PST 1.03's
Thanks in advance.
AlV
I want to swap in a set of PST 1.03's
Thanks in advance.
AlV
I may never use one again. I actually built one, but after installing headers, it won't work, LOL
I just unhook the front strut, and you have to look and "figure" to do this........get up in there with a large bar and maybe a 2x4, etc, and pry the LCA to the rear. They come right out
I've done with just loosening the big nut on the LCA.You can pry it out a half inch at a time.
Pry LCA to the rear, hold bar, release prybar, repeat . Easy, peasy.
The UCA has nothing to do with it. The UBJ just hangs on it and is free to move in any direction.
If your bars are factory, then they will likely almost fall out. If your bars are aftermarket with the re-clocked ends, they can be "sticky".
Just go try it,already! lol