Here is my Classic Dash Bezel for my 69 Barracuda.
They don't make the piece for the glove box. Talked to the president of the Classic Dash and he said they were not planning to make the glove box piece any time soon.
I'm going to make my own and then re-finish both pieces so they match...
Will Hydro Dip them with a Carbon Fiber pattern.
Have to relocate the wiper switch and it is radio delete.
It is made for 5" Tach & Speedo and 2-1/16 for the small gauges. Auto-meter is what they sell.
I don't care for any of the Autometer gauges though.
I'm going Speed Hut for all the gauges. 8K Tach, 160 GPS Speedometer, Volt, Temp, Oil Pressure and Fuel will fill all of the holes.
Thought about moving the heat controls down where the radio is and stereo where the heater controls are like RedFish, it should be easy to do.
May see if a double DIN with GPS, DVD & Touchscreen will fit... May just go hidden stereo. Have some time before I have to decide.
Car is getting sheet metal replaced right now.
Just a first test fit here. Held with painters tape.
Stupid that they do not make the glove box piece but I can work with it.
Have to make some adapters for the SH 4.5" gauges to fit the large holes.
Might purchase a 3D printer and make them that way. Good excuse to buy one.