Complete Magnum swap

[monker]

Hi, I am new to this forum and was hoping to get some advice or input on my planned swap. I have seen a ton of info on here from people swapping Magnum motors but all have been converted to carb application. I have a complete Magnum 5.2 with rebuilt transmission wiring harness and computer from a 92 Dakota. My plan was to break down the harness to only what is needed to run the drive train and further down the road swap in a built up fuel injected 408 stroker Magnum when I am ready. I plan on adding an M1 manifold and some other goodies since they will all be useable in my stoker build later. I had considered the Hemi swap but this seemed a touch easier and a little more different than builds I have seen.

My car is a 67 Barracuda I am restoring and repainting plum crazy.

Any links to simmillar builds or ideas would be appreciated. Thanks, Jeff

 

[needsaresto]

Hi, I am new to this forum and was hoping to get some advice or input on my planned swap. I have seen a ton of info on here from people swapping Magnum motors but all have been converted to carb application. I have a complete Magnum 5.2 with rebuilt transmission wiring harness and computer from a 92 Dakota. My plan was to break down the harness to only what is needed to run the drive train and further down the road swap in a built up fuel injected 408 stroker Magnum when I am ready. I plan on adding an M1 manifold and some other goodies since they will all be useable in my stoker build later. I had considered the Hemi swap but this seemed a touch easier and a little more different than builds I have seen.

My car is a 67 Barracuda I am restoring and repainting plum crazy.

Any links to simmillar builds or ideas would be appreciated. Thanks, Jeff

Frank Adkins book "How to build hi performance chrysler engines" has some good info on this subject. It has a few sections on swapping in a magnum,carbed or fuel injected.