[FOR SALE] custom drive shaft metal not stock

-
Status
Not open for further replies.
68cuda78

68cuda78

Well-Known Member
Joined
Feb 16, 2011
Messages
693
Reaction score
7
Location
Indiana
Rating - 100%
6   0   0
Contact seller
Reason I say custom is not do to length but just being aftermarket. Its not the heavy stock cast one its metal. I had it in my 71 dart with a small block and 727 trans. It had stock location 8 3/4 in it so should fit your stock located rear. I will measure it later from center cap to center cap and total length. 100.00 plus shipping and if paypal is used 3 percent. Also comes with yoke and I believe it is the small one
 

Attachments

  • 20130824_084305.jpg
    107.4 KB · Views: 414
Measure centerline to centerline of the bearing retainers, what is it? Thanks.
 
68cuda78 said:
Yes
Click to expand...
This info is totally incorrect
rumblefish360 said:
Same wheel base as a '71 Duster?
Click to expand...

NO it wont come close to fitting
67-76 Dart Swingers and Valiant 2 and 4 Doors as well as Dart 4 Doors Have a 111 inch Wheel Base
70-76 Duster, Demon(70-72), Dart Sport Have a 108 Inch Wheel Base

This driveshaft would need to have at least 3 inches cut off to come anywhere near fitting a Duster
 
74DartSwinger360 said:
This info is totally incorrect


NO it wont come close to fitting
Dart Swingers and Valiant 2 and 4 Doors Have a 111 inch Wheel Base
Duster, Demon, Dart Sport Have a 108 Inch Wheel Base

This driveshaft would need to have at least 3 inches cut off to come anywhere near fitting a Duster
Click to expand...

Thanks I figured they were the same. Thats why I love this site
 
Status
Not open for further replies.
-

Back
Top