Would anyone know on the Phoenix Graphics tail stripe for the 70-72 Dart if the marker lights location is pre-cut out of the stripe? Thanks
I guess nobody uses Phoenix Graphixs stripes lolno problem thanx
It would be nice if they were all the same from the factory, but no deal Here's where mine are and I think it was mostly View attachment 1715611935 determined by the bottom of the stripe at the valance (which also has to be cut through at the joint after it's in place) and the bend over the quarter. I'll try to send a close-up tomorrow.
Here you can see that I did not cut it at the joint like str12 mentioned. Boy do I wish I did, because I couldn't figure out how to sink it into the recess of the joint by just working it with the tools I had.Here's where mine are and I think it was mostly determined by the bottom of the stripe at the valance (which also has to be cut through at the joint after it's in place) and the bend over the quarter.