mopar_mudder
Active Member
I don't think so but does anyone make the panel that is between the A pillar and fire wall? If not looks like I am making and fixing.
Does Anyone Make This?
- Thread starter mopar_mudder
- Start date
-
Not that I have seen. AMD if anyone would. It would help to know what you are working on.
mopar_mudder
Active Member
Sorry it is a 74 Dart Sport
the other questions...
what else uses the same or close enough panel?
are you doing a full boogie restore that you care how correct it looks?
how much of the panel do you need? all of it including the seams, or, are the edges good and you could fabricate the rest of it out of 16 gauge?
what else uses the same or close enough panel?
are you doing a full boogie restore that you care how correct it looks?
how much of the panel do you need? all of it including the seams, or, are the edges good and you could fabricate the rest of it out of 16 gauge?
mopar_mudder
Active Member
It is mainly the lip where the firewall attaches and about 2" up from the rocker that is bad. I can make it if I have to, it is just alot faster to replace then make and seam weld in pieces.
I have one for sale, question is when I will have time to cut it out.
mopar_mudder
Active Member
I could use both sides but need it pretty soon. If I can get it I will just have to start fixing them this week end.
They make it for E body only as far as I know.
moparmat2000
Well-Known Member
FYi it's the same stamping from 67-76 all A body.
-
