[FOR SALE] Edelbrock 340 heads

-
Status
Not open for further replies.
stroked340

stroked340

Well-Known Member
Joined
Jun 14, 2014
Messages
5,257
Reaction score
2,948
Location
mass.
Rating - 100%
1   0   0
Contact seller
Selling my Edelbrock 60179 heads these have been c c'd ported by Hughes engines at that time they opened up the intake valves to 2.08 and enlarged the push rod holes.after that my engine builder installed high quality springs,retainers and 10 degree locks,springs are good to .700 lift these heads are still wrapped in plastic from the shop,never installed..want $1900.00 I have a lot more then that in them..p.m. me or email me..

IMG_0650.JPG


IMG_0651.JPG


IMG_0653.JPG
 
Any receipts for the work done to the heads, flow bench #’s, etc?

What’s with the orbital sander treatment on all the surfaces?
 
72bluNblu said:
Any receipts for the work done to the heads, flow bench #’s, etc?

What’s with the orbital sander treatment on all the surfaces?
Click to expand...

Got the paper work from Hughes.. they had some old gasket material I cleaned off,ran these heads on another motor before all the new work was done..
 
stroked340 said:
Got the paper work from Hughes.. they had some old gasket material I cleaned off,ran these heads on another motor before all the new work was done..
Click to expand...

Oh ok. So they’re used heads you sent to Hughes, but they haven’t been run since the new work.

Thanks for clearing that up!
 
gtsdude said:
What kind of porting was done? Any pics of inside the ports?
Click to expand...
Up top you can enlarge the posted pictures to see the port work done. The second picture shows the porting and enlargement of the intakes port window.
(IMO, this is an excellent deal)
 
These are a great deal but do they come with a hardened intermediate shaft?
 
Status
Not open for further replies.
-

Back
Top