Baxter61
Well-Known Member
Edelbrock Performer RPM Air-Gap intake manifold and Holley 750 DP carb setup for SB. Manifold is used and has been cleaned and painted with high temp engine paint. The manifold is unported. The carb was a good running carb pulled from a vehicle. It is not a dipped rebuild. It does however have non-stick gaskets on both fuel bowls and metering blocks, new needle and seats, and new nylon gaskets on the needle and seat and fuel bowl screws. It is a 2 corner idle with a manual choke. It has jets and a power valve in it currently but if you tell me what you want in it I will see if I have the stuff to make it happen. $450 plus shipping from Oregon City, OR 97045 (shipping will likely be around $50 in the continental US) Paypal accepted as a gift or add 2%. PM me on the board!
