Dos anyone have a picture or print with dimensions of the dollie that you can use to lower the k frame with engine and transmission out from the bottom of the car?
I did the same thing with wheel dollies under a piece of 1 1/8 plywood tapered the cut to fit inside my engine hoist wheel frame. Secured the dollies to the plywood with 1x3 wood screwed into it. Motor tranny and headers installed. All stuff I had in the shop.took old motor and k out and put the new in by myself. Take your time and it's no problem.
Thanks guys, i appreciate the low bucks approach, but i was hoping to see one made from square tubing that i could possibly start the engine on. If i find one, or build one, i'll post a pic of it. Thanks again,
Tom