Engine to Transmission bolts

[SRT_DSTRHOLC]

Or what can I use?

 

[robertnb64]

If you have a junk yard near by vans are a great source...easy to get to.

 

[SRT_DSTRHOLC]

what about new bolts like grade 8 ones that I use for the motor on the engine stand, but correct length for the motor to trans

 

[doktor_x]

what about new bolts like grade 8 ones that I use for the motor on the engine stand, but correct length for the motor to trans

The factory bolts are probably grade 5, but overkill is just right on these things. The grade 8 bolts should be fine.

 

[robertnb64]

They should be strong enough. They just won't look stock.

 

[70aarcuda]

they look just like the intake manifold bolts...

 

[GoodysGotaCuda]

I wanna say they are 3/8"-16, about 1 1/4" long bolts that would be installed in the car. Then there are two larger, 7/16"? bolts. Any ace hardware or truevalue should be able to have what you need

Quick way to see what diameter bolt it is, is to just grab a wrench and stick the open end over the bolt. 3/8" bolt will just clear a 3/8" wrench..

 

[daredevil]

never realized that Goody. I always have a caliper handy in the garage. Nice tip. By youre zip youre not far from Orlando?

 

[GoodysGotaCuda]

Yep, not far from Orlando. Well for another month and I'm loaded up and headed back to Las Vegas.
-Mike

 

[SRT_DSTRHOLC]

is there a site that will help me or sell them?

 

[robertnb64]

http://www.mrgusa.com/fasindex.htm

 

[SRT_DSTRHOLC]

nice but were exactly are they on there?