I'm contemplating buying a 2005 Dakota that comes with a 4.7 magnum. I'm fairly well educated on 5.2 and 5.9 magnums, but this is a new one for me. Any feedback on this engine, good - bad - or indifferent?
Doesn't this kind of go against the whole getting rid of stuff?I'm not buying anything?????????......I'm contemplating buying a 2005 Dakota that comes with a 4.7 magnum. I'm fairly well educated on 5.2 and 5.9 magnums, but this is a new one for me. Any feedback on this engine, good - bad - or indifferent?
Looking at selling the two I have and downsizing to a mid-size truck.Doesn't this kind of go against the whole getting rid of stuff?I'm not buying anything?????????......
At least that's the way I remember it, where i'm getting really old here, and I can't remember very well....
Rusty that happened to the first while whale, a 5.2. Dodge went to those God Damned "trumpet" oil pickups. the tube simply comes and bends straight down, and there's a small screened "trumpet" on the end. They plug up with sludge.The only thing I've ever heard about them is straight out of the mouth of a Jasper Engines rep. He was telling us about how they used revised oil pump pickups that were larger and flowed more oil to help combat cooked oil in the pickup tube. He said they had seen a LOT of cores with either very restricted pickup tubes or completely stopped up tubes and that was their fix for it. Other than that, I have no experience.
I've heard the dot 7 thing as well.Rusty that happened to the first while whale, a 5.2. Dodge went to those God Damned "trumpet" oil pickups. the tube simply comes and bends straight down, and there's a small screened "trumpet" on the end. They plug up with sludge.
See post 4:
For my turbo-teen I did all the oil mods except the crossover tube on a mag block. Including grinding out the #5 cap and pump. For the pump Intake and pickup I was going to tap 1/2 NPT and run a copper tube to a fancy sheet metal pickup and mesh screen that will sit inside my homemade baffled pan. I have a standard volume pump I’m a new dad (again) and funds are low so I’m trying to finish this up free.
I have some silver solder I picked up from a friend to fuse the copper tube to the the sheet metal screen box. I figured I can bend the tube easily by hand with sand.
Since I did the...
- T56MaxTorq
- Replies: 13
- Forum: Small Block Mopar Engine
Regarding 4.7's, suddenly they are good?? I used to hear horror stories about them failing, dropping valves/ valve seats was one issue.
The joke used to be that Mopar, "anything dot 7 is junk." AKA 2.7, 3.7, 4.7, and even a few of the 5.7's
My friend over there in hazeldale has one of those four sevens in his truck and pulls the snowmobile trailers and everything.And they're well known to be three hundred thousand mile motors, as well as the 5.2.And the 5.9....Looking at selling the two I have and downsizing to a mid-size truck.