First Gen Barracuda Interior Trunk Trim?

[dibbons]

Recently I found a thread concerning a factory piece of trim that covered the area of the very rear of the trunk where the tail light wiring harness runs (and trunk latch). But now I lost it. Anyone can direct me to the thread (or better yet explain or present photos) with information regarding that not so well-known part? I was wondering if the "clips" located back there (see photo #2 with finger pointing to one of 'em) are made to secure the wiring or made to secure the trim piece ? And are there two pieces of trim (right and left) or just one long piece? Thank you.

 

[pishta]

Can check my survivor in about 40 minutes....

 

[Rick@Laysons]

[WANTED] - '66 Barracuda trunk part | For A Bodies Only Mopar Forum

 

[dibbons]

It looks like there is not a consensus on whether the trim is attached in front of the two braces that contain the fastener holes (photo #1) or behind the braces (photo #2).

And the two drilled holes in my photo in post #1 show the holes located very low on the braces and not centered higher up.

 

[cudamark]

All the ones I had/have, the panel was mounted like your first photo.