Well its been around two years since I have posted, my 70 swinger has been tied up in a ugly divorce for almost 3years. I finally got it back and picked my motor up from the shop on Fri. Its a R3 block, 442ci, all the good stuff on the low end, indy 360 heads and intake, F1 procharger with water injection. The cam is a comp hyd roller that was spec'd by the Super charger store, who by the way are great people and really no there stuff.
It made 977hp, 872ft lbs @ 6000rpm, and made 18lbs boost. This was all done with a 4.5 inch pulley, we had a 4 in pulley but didn't even try it, all the numbers were perfect, but it would certainly make well over 1000 with the 4 in pulley.
So I started to install it over the weekend, and ran into a big snag, since its been 2.5 years the motor has been out, I have lost a mount and had to call Bill at RMS and order another one. Hope it gets here tomorrow!!
It made 977hp, 872ft lbs @ 6000rpm, and made 18lbs boost. This was all done with a 4.5 inch pulley, we had a 4 in pulley but didn't even try it, all the numbers were perfect, but it would certainly make well over 1000 with the 4 in pulley.
So I started to install it over the weekend, and ran into a big snag, since its been 2.5 years the motor has been out, I have lost a mount and had to call Bill at RMS and order another one. Hope it gets here tomorrow!!