heres the build. fishy 68 assembled the motor, he does very nice work. .40 over 340 block , steel scat crank, scat rods, steel crank scraper, 8 qt pan milidon, mellings pump worked over by fishy. diamond pistons , 11.8 compression, eddy ported -stock valve . flows 277 at 600, 215 on the ex side, the cam is a ultra dyne solid mech cam, specs are 263 in 0.50 267.0.50 ex. lift with 1.6 is 637 in 651 ex with 1.6. rockers are prw stainless , i have had no problems with these rockers , but i did have to do some clearence work on them, they were on my 340 first.the intake is a eddy t-ram , port matched, i just swapped from 660 holley center squirters-e-85 to 2-750 holley vac secondary carbs -E-85 converted, with .180 downlegg boosters. i had 4.10s in it, im swapping to 3.91 with a fresh clutch type sure grip. tires are 28x13.50 et streets, vertor is a 9.5 in. flashes about 5000 rpm. 727 manual valve body . shes not a everyday driver . hoping to run it around 1 or 2 times a week. just finally got it insured. 3 inch ex. with dyno max muffs and 1 3/4 hookers. :burnout: