Tackweld
Active Member
After replacing the leaking oil pressure fitting on the 360 block, I of course had to start it up and test my pipe fittin' skills. As the mill was idling, I catch a glimpse of this "fog" coming up and out the vent, then getting sucked down the carb. So.....Is this normal?? I'd appreciate some feedback on this, Thanks
Short YT Vid [ame]http://youtu.be/mAMcRmIyyqg[/ame]
I'm rank novice on Holley's- this is a 750dp. I've had others dp's and vacuum sec's in the past, just don't recall seeing this...
Did get that oil leak stifled though...
Jeff
Short YT Vid [ame]http://youtu.be/mAMcRmIyyqg[/ame]
I'm rank novice on Holley's- this is a 750dp. I've had others dp's and vacuum sec's in the past, just don't recall seeing this...
Did get that oil leak stifled though...
Jeff