Have any of you Holley guys seen this one? Choke is wired to hot side of ignition, it opened to full open after start up. Any advice on what is going on? Choke is adjusted to the factory marks. Thanks a bunch....
12 Volt run side of ignition switch, has power, tab is in spring.. Thanks for the input.....
I am letting the motor cool down, then I will richen up the joke setting, if that don't fix it, it might be the spring... ThanksThen try to turn the choke housing until the choke engages when cold and is straight open when warm...
I am letting the motor cool down, then I will richen up the joke setting, if that don't fix it, it might be the spring... Thanks
It is cold down here too, 16 this morning.. ThanksYou can get a good ballpark when it's warm by turning the housing until the choke butterfly just reaches vertical. then confirm when cold - it takes a few hours for it to fully cool, depending on the outside temp...
Bring it up here and it will be cool in a half hour - we're sitting at 16° F right now... Our hi for the day...
It is cold down here too, 16 this morning.. Thanks
Mine is always open till I first press the gas. Flips closed on the first pump for start up, then slowly opens.
I always adjusted this wayYou can get a good ballpark when it's warm by turning the housing until the choke butterfly just reaches vertical. then confirm when cold - it takes a few hours for it to fully cool, depending on the outside temp...
Bring it up here and it will be cool in a half hour - we're sitting at 16° F right now... Our hi for the day...
Choke is adjusted to the factory marks.
wheres the mark at?