Lunati cam card info

[66Valiant528]

I waited on hold yesterday with Edelbrock/Comp for 33 minutes and had to hang up. I've been to the Lunati web site to no avail. Does anybody happen to have any more info on this cam? Install centerline? These numbers are from Summit. Small block solid.

 

[1MeanA]

Page 76 says its on a 106 ICL
https://images.carid.com/lunati/items/pdf/lunati-product-catalog.pdf

 

[66Valiant528]

Page 76 says its on a 106 ICL
https://images.carid.com/lunati/items/pdf/lunati-product-catalog.pdf

Thank you!

 

[Bewy]

The adv & 050 numbers [ major intensity ] look suspect to me. Only 29* between adv duration & 050 duration.

 

[1MeanA]

The adv & 050 numbers [ major intensity ] look suspect to me. Only 29* between adv duration & 050 duration.

If you add the 0.016" lash the numbers would make sense.

 

[PRH]

Probably no one left to ask anymore, but I think those lobes are something Harold B brought over from UD when he went to work for Lunati.
The 272/243 exhaust lobe was already developed when UD still existed, he just needed to scale it down some for the companion 264/235 intake lobe.
They’re part of the UD “NF 904” lobe family.

 

[Two Time Signet]

Tried to find your cam card but wasn't for the specific LA grind. I've been able to find them for my big blocks.

 

[TT5.9mag]

Probably no one left to ask anymore, but I think those lobes are something Harold B brought over from UD when he went to work for Lunati.
The 272/243 exhaust lobe was already developed when UD still existed, he just needed to scale it down some for the companion 264/235 intake lobe.
They’re part of the UD “NF 904” lobe family.

Read; fast *** lobes

 

[1MeanA]

Read; fast *** lobes

If the 264/272 are 0.006" numbers they sure are

 

[PRH]

It’s a SFT, so the 264/272 numbers are taken at .020”

 

[Dart Frog]

It’s a SFT, so the 264/272 numbers are taken at .020”

Is that standard for all solid lifter camshafts?

 

[aaronk785]

Man, I miss those lunati cams. They were good quality and performers.

 

[PRH]

Is that standard for all solid lifter camshafts?

It’s not, but several cam grinders have adopted that spec for their more race inspired SFT lobes……. UD being one of them.

 

[Mobin]

That's funny, I pulled mine off the shelf the other day to run desktop dyno numbers. Then scrolled to this post.

 

[RustyRatRod]

It’s not, but several cam grinders have adopted that spec for their more race inspired SFT lobes……. UD being one of them.

That's why I really Oregon regrinds. They give you SEVERAL checking points.

 

[66Valiant528]

That's funny, I pulled mine off the shelf the other day to run desktop dyno numbers. Then scrolled to this post.

View attachment 1716535316

And what did the desktop dyno show?

 

[Mobin]

422hp at 5590rpm