MC pushrod parts needed

[pauls340]

So I really need that little rubber seal at the end of the rod. This one goes in but when I try to pull the rod out...it comes out by hand....and it shouldn't. Somebody has to sell these. Any help is appreciated. Thanks.

 

[AJ/FormS]

Once it is installed, you will have to want to dislodge it, to actually dislodge it;but it could happen I suppose, in a panic situation.
Does your M/C have the proper receiver-groove for it?

 

[pauls340]

yes the MC is correct. Why can't I use the correct outside diameter rubber hose and slice it the correct width as the current seal is?

 

[AJ/FormS]

That's a pretty good idea except the hose may not last long. Now, a nylon tube would work;the kind they use in pressure systems. Or a square section O-ring cut to fit, say from an old caliper piston(do not oil it!)
I suppose your idea would work, until it got brake fluid on it.
Whatever you use, do not oil it.Use the silicon O-ring lube, if you have to.

 

[ValiantOne]

Mancini Racing Brake Pushrod Bushing

$3.95 the last time I bought one.

Best,

CE

 

[pauls340]

So I really need that little rubber seal at the end of the rod. This one goes in but when I try to pull the rod out...it comes out by hand....and it shouldn't. Somebody has to sell these. Any help is appreciated. Thanks.View attachment 1714956387

 

[pauls340]

Thanks, Mancini isin town here.