Mystery seat

[PWdart]

I thought this seat was for my 69 dart. But it’s not. It looks a hair too narrow. It’s definitely too short and the clips that hold it to the floor are also too narrow. What could it be for?

 

[Elmer-FN-Fudd]

it looks correct to me, but it may work better if you put the back on first. Also, I noticed you don't have the side panels on, that will make a difference in how it fits and looks.

 

[Killer6]

That won't fix the retaining hook mismatch,.. maybe for a convertible, or....?

 

[Elmer-FN-Fudd]

seat is pushed way too far back, hard to tell in that picture but it looks like it would work if in a more forward position.

 

[72dustervs]

worst case you could move the tabs on floor over to match the seat if the seat matches other seats in car , might just be a difference in year of the car it came out of as it does look to be a correct seat

 

[RustyRatRod]

seat is pushed way too far back, hard to tell in that picture but it looks like it would work if in a more forward position.

Yeah like 3" too far back. If you look close, you can see the part of the seat frame that goes into the bracket.......just behind the bracket.

 

[Elmer-FN-Fudd]

Just noticed, did you replace those hooks, they look like they are on backwards

 

[Cranky]

Yeah, install the seat back first then lay the bottom down and see what happens.

 

[PWdart]

I found the correct seat. I was just wondering what this one is from because I’d like to sell it. It’s close, except for where it hooks into the floor.

 

[Elmer-FN-Fudd]

might be for a duster