Need an A body driveshaft 727 to 8 3/4

[Thrasher]

I have a 1972 Dart with a 360, 727 and an 8 3/4 posi... does anyone have any for sale, or if no one has it does anyone know the exact measurement so maybe I can look for one elsewhere?

:toothy9:

 

[moparsegura]

ok, I'm not sure what the hell I just read. Are you looking for a car or selling a car?

 

[moparsegura]

oops, my bad, I see now you are looking for a driveshaft. I made one for my 69 cuda. also a 727 with 8 3/4. I used a 86 dodge truck longbed shaft, but cut out about 16 inches. Even the same size u-joints.

 

[DemonDave]

If it's a Dart Sport (Duster body), you'll need a driveshaft measuring 45 1/4" u-joint to u-joint. That's what I just put in my Demon after my 360/727/8.75 swap. Add 3" if your car is a Swinger (111" WB vs. 108" WB).

 

[DemonDave]

Here's one for sale here on FABO:

http://www.forabodiesonly.com/mopar/showthread.php?t=39011

 

[physixx]

I've got one from a 75 Duster 4-speed OD and 8 3/4. Measures 49" center-center of the U-joint. Uses the small U-joint. Included is the trans slip yoke that will fit the 727. I would replace the U-joints though.

Here is a good link that I got from another site for D/S lengths.

http://www.autohobbydigest.com/tables.php?17_driveshafts_slip_yoke


Ken
Edison, NJ
[email protected]