need some advice, running 3/8" fuel line, how to run, what to use

[Ott]

Ya know, it's right at the frame rail, but not lower.

This is where I'm at right now, coming off the fuel filter going into the dual feed carb line. Is it okay if I come off the back of the feed with a 90deg. fitting then go into the fuel pressure regulator?

View attachment 1715214587

View attachment 1715214588

View attachment 1715214589

View attachment 1715214590

That’s how I plan to plumb the regulator when I rework my fuel system.

 

[69_340_GTS]

Ya know, it's right at the frame rail, but not lower.

This is where I'm at right now, coming off the fuel filter going into the dual feed carb line. Is it okay if I come off the back of the feed with a 90deg. fitting then go into the fuel pressure regulator?

View attachment 1715214587

View attachment 1715214588

View attachment 1715214589

View attachment 1715214590

That is how I did mine. Might as well make the hoses as short as possible, plus a little less exposure to heat coming off the engine. Cleaner looking too.

 

[mopowers]

If you wanted to clean it up a little more, you can always mount the filter closer to the pump.

 

[roylerumble]

That is how I did mine. Might as well make the hoses as short as possible, plus a little less exposure to heat coming off the engine. Cleaner looking too.

I'll post pics of what I ran for scrutiny later. I did add a heat shield over my line that ran close to the headers. They're ceramic coated too, so I'm sure I'll be okay.

 

[roylerumble]

Nice RMS k member too...