Need to raise ride height

[Mopar to ya]

I have my new mono leafs in and instead of the 1" lift promised, it lowered an inch. I adjusted the torsion bars to level the car, but my aftermarket skid plates, (headers) bottom out on occasion. I would like to raise the rear, then crank the torsion bars up a turn or two in the front. What is the best way to raise the rear. I have caltracs and can't use extended shackles, but I hate them anyway. Any suggestions?

 

[72BBSwinger]

Raise the front eye by whatever means available. If you raise the front only say 1" it will only raise the rear 1/2" though. Bummer they didn't give what they said. Might be able to find someone who has Caltracs that wants their car lower and swap.

 

[Hemiroid]

Remove your mono leaf springs and have them re-arched.

Kenny

 

[pettybludart]

I,ve read about flipping your front hangers,but need to open up 1 or 2 holes for the studs to fit properly.Just a thought.:yawinkle:

 

[1968FormulaS340]

I,ve read about flipping your front hangers,but need to open up 1 or 2 holes for the studs to fit properly.Just a thought.:yawinkle:

That will lower it, but checking to make sure they haven't been flipped in the past would be a good idea.

 

[trapster]

I checked to see if I could flip my front hangers and you can't, they only go in one way.

you could just get add couple of helper leaves.