New BB heads from Edelbrock?

[69dodgedart360]

Hey everyone picked up the 2009 Edelbrock Catalog at the Goodguys car show and saw these new heads for BB Mopar P# 51929 called the "RPM Extreme" heads but when i run the part numbers through summit jegs or even edelbrock its not found anywhere has enyone heard of these? they say they are CNC ported so i figured if i was going to buy some good heads for my motor i might want to look into these new ones and start saving.

 

[rumblefish360]

I got the catolog as well and there not out yet.... or so I thought.

 

[69dodgedart360]

anybody have any idea when they are coming out?

 

[dusterdon]

Probably cheaper to get old eddy's or stealths and get them to Modern cylinder head for their cnc porting.

 

[69dodgedart360]

what would be a ball park figure on cnc porting? $1000?

 

[moper]

To have a set of heads of yours done is I think around $1000 depending. There are other charges, such as proper springs, and hardware those require, slotting pushrod holes if needed, and the valve job. I would advise if possible, just buy a new set done. The new set runs about $2500 depending and comes ready to install. You also only pay shipping one way saving a couple hundred bucks.