Hello all Mopar guru's, I just installed a 340 in my Dart, motor is freshly rebuilt. I've primed the motor prior to break-in, no oil pressure....uhm...removed the oil filter....no oil in the filter...uhm, removed the pump, checked the pump on the bench....lots of oil, works fine...uhm....reinstalled the pump, still no oil pressure....removed the pump checked to see if the plug is installed in the block under the rear main cap...there.... uhm...changed the pump, re-installed... still no oil going to the filter....UHM checked to make sure that the upper rear plugs are there....there....UHM!, turned the key on and turned over the engine, re-primed the pump...Still no oil pressure....I think i covered all of my bases, but I'm stuck and hoping all of my friends here at FABO can help me out...