NOS 67-69 Cuda panel- what is it??

[Hemihead2]

I need help identifying these pieces please. The part number isn’t one I could readily find. It looks to me that it is the driver’s side C-pillar/ upper quarter but I’m not sure..

The second smaller piece is a section of the other piece.

Lastly, there are a pair of quarter panel wheel lip radius panels with no part numbers.. all this was included with some 67-69 Barracuda parts..Thoughts? Thanks!

 

[68383GTS]

Yes the 1st part is the interior rear panel that goes by the rear glass

 

[Hemihead2]

Do they repop it?

 

[Hemihead2]

It’s the same piece from a different angle in the second picture.

 

[68383GTS]

It’s the same piece from a different angle in the second picture.

No...they don't repo it

 

[B'cuda]

I need help identifying these pieces please. The part number isn’t one I could readily find. It looks to me that it is the driver’s side C-pillar/ upper quarter but I’m not sure..

The second smaller piece is a section of the other piece.

Lastly, there are a pair of quarter panel wheel lip radius panels with no part numbers.. all this was included with some 67-69 Barracuda parts..Thoughts? Thanks!

View attachment 1715146415

View attachment 1715146416

View attachment 1715146419

View attachment 1715146420

View attachment 1715146421

It does look like the top of a rear quarter panel, someone may have trimmed down a panel for lower damage or rust repair, or and radiused a set for racing and these are the leavings.

 

[4spdragtop]

Agree with above posts, looks like FB stuff.

 

[68383GTS]

Ya I think B'cuda is right top of a rear quarter that was cut down.

 

[TheGrateRonzini]

Maybe the top piece was leftovers from a notch. I’m going to have to cut close to the same part off of my new ones from AMD.

 

[autoxcuda]

Wheel lips don’t have that inward contour that all 67-69 Barracuda’s have.

 

[B'cuda]

Wheel lips don’t have that inward contour that all 67-69 Barracuda’s have.

You are correct. Not from the same qtrs