"PLYMOUTH" header lettering

[67barracuda]

Looking for a template that defines the spacing and where to drill holes for a 67 barracuda PLYMOUTH lettering across the front header.

 

[cudaspaz]

Can you hit a junk yard and try to find one then trace the holes on paper or poke through them with a pencil?

Maybe someone here has their letters off their panel and can make you a template.

 

[67barracuda]

I'll never find one in a junk yard here in michingan. Dose any one have one they can trace and upload?

 

[paulh70]

Looking for a template that defines the spacing and where to drill holes for a 67 barracuda PLYMOUTH lettering across the front header.

I just removed the letters from mine I can take a picture and send to you or trace it and mail if you need.

 

[Rocky_JS]

ugh that's a lot of holes to drill!

 

[RedFish]

Be absolutely sure you have the correct letters for a 67 Barracuda before drilling the holes.

 

[67barracuda]

It's time, can anyone help me out?

 

[TrailBeast]

You really need that traced and mailed to you.
The reason is that photos cannot represent the correct distances.
If you had even a traced template from another car, would be the ticket.

It's time, can anyone help me out?

 

[RedFish]

I piece craft paper templete, 12.00 plus postage. Rolled and tuved will cost a little more than folded. If I could do it for free I would. The header panel is tied against the wall on the front of the rear seat frame, 10 feet off the floor. Covered with a trap too.
If someone else doesn't come through for you, soon PM me. Good luck

 

[67barracuda]

That would be great. Will paypal work for you.

 

[RedFish]

That would be great. Will paypal work for you.

Yes sir paypal is fine. Send me a PM.