Pulley question

[Thunder]

I started removing unneeded accessories from a 440 I am putting in my Dart Sport. The motor was cut from the vehicle { unknown } with a torch. They cut the K frame, steering column, and everything else. After removing the steering box, power steering pump, and A C compressor I realized that the pulley for the water pump is run off the power steering pump. My question is, does Dodge make a three groove pulley for the water pump or would I be better off going with an electric pump?
The motor is a '73. The #s on the pad are 4 T 440 E if that helps any.

Thanks in advance.:coffee2:

I am pulling a decent running /6 w 904 out if anyone might be interested.

 

[abodyjoe]

better off putting the proper pulleys on the car...

sounds like your going 440, with power steering and no a/c. is that correct??


here is the alt bracket you need.. http://www.bouchillonperformance.com/BPE5250.asp

the attached are the pulleys you need for the wp and crank. use the measurements as a reference for used ones.

 

[Thunder]

No power steering no AC :coffee2:

 

[abodyjoe]

No power steering no AC :coffee2:

then you use the above wp pulley and alt bracket and the attached crank pulley.. although the previous one will also work....

 

[Thunder]

Thank you. I will check into these.:coffee2:

 

[abodyjoe]

yup..

you can buy them new here: http://www.bouchillonperformance.com/



or use the measurements and find used ones.. a lot cheaper used..lol



.