canyncarvr
Well-Known Member
Existing parts: Edlebrock RPM Performer with Holley 4150.
Intended change: Adding 1/2" phenolic spacer under carb for heat protection.
I am using the OEM throttle cable bracket. It bolts into existing bolt bosses on the intake just fine.
Can someone recommend a bracket that will get me a bit more height and still retain the reasonably correct pull angle by the cable?
I don't have a ton of room to raise the OEM cable, but 1/2" shouldn't be a problem. If someone knows better, that a new cable is necessary, I would appreciate hearing about that too. I could just add a bit of spacer under the existing bracket, but that changes the angle as much as raises the bracket. It might work just fine.
Thanks!
Intended change: Adding 1/2" phenolic spacer under carb for heat protection.
I am using the OEM throttle cable bracket. It bolts into existing bolt bosses on the intake just fine.
Can someone recommend a bracket that will get me a bit more height and still retain the reasonably correct pull angle by the cable?
I don't have a ton of room to raise the OEM cable, but 1/2" shouldn't be a problem. If someone knows better, that a new cable is necessary, I would appreciate hearing about that too. I could just add a bit of spacer under the existing bracket, but that changes the angle as much as raises the bracket. It might work just fine.
Thanks!