67Dart273
Well-Known Member
in Coeur d Alene, ID asking 1500.00, trades, etc
Fixed this up thinking I was going to move out of town. Ya.
Cletrac, what, HG? I bought with junk engine, converted to Toyota 20R, Toy 4 speed drives Cletrac 3 speed. New seat, hydraulic hoses and valve. Needs throttle / governor control built but runs as is, has governor spring tied back to run. Probably needs track work, I'm no expert on dozers. Bought this as a "fun project," and have used it for plowing the alley in winters, as well as around front after the streets snow packed.
Wired for lights but not installed, dash, wiring done and properly functional, alternator, 12V system. Fuel tank was cleaned and coated inside with the POR-15 stuff, no fuel problems. Sheet metal was off Massey Harris 33? 44?
Unfortunately I paid "a lot" for a really nice grille, and ran a big stick up through it last few winter.
Starts and runs well, steering brakes seem to work OK. Manual angle blade
I have WAY more into this than I care to admit, make offer, partial trades? cash talks
I can haul reasonable distance, some fuel/ time / labor needed for outside immediate CDA area
Here's the progress from day1 LOL I still have "the remains" of the ROP if you want that
http://cletrac.org/forum2010/index.php?topic=2321.0
Fixed this up thinking I was going to move out of town. Ya.
Cletrac, what, HG? I bought with junk engine, converted to Toyota 20R, Toy 4 speed drives Cletrac 3 speed. New seat, hydraulic hoses and valve. Needs throttle / governor control built but runs as is, has governor spring tied back to run. Probably needs track work, I'm no expert on dozers. Bought this as a "fun project," and have used it for plowing the alley in winters, as well as around front after the streets snow packed.
Wired for lights but not installed, dash, wiring done and properly functional, alternator, 12V system. Fuel tank was cleaned and coated inside with the POR-15 stuff, no fuel problems. Sheet metal was off Massey Harris 33? 44?
Unfortunately I paid "a lot" for a really nice grille, and ran a big stick up through it last few winter.
Starts and runs well, steering brakes seem to work OK. Manual angle blade
I have WAY more into this than I care to admit, make offer, partial trades? cash talks
I can haul reasonable distance, some fuel/ time / labor needed for outside immediate CDA area
Here's the progress from day1 LOL I still have "the remains" of the ROP if you want that
http://cletrac.org/forum2010/index.php?topic=2321.0
