Shoulder belt attach point 68 Barracuda FB

[Steve Kranz]

Planning to put shoulder belts in my newly restored 68 Barracuda FB. Looking for the holes above the window on the inner roof structure that anchor the upper bolt. Can't see the location because I have a brand new headliner installed. Maybe some of you have access to a Cuda body without a headliner, and can possibly provide some dimensions so I can at least find the approximate location. Again, thanks in advance for any advice you can provide!

 

[Daves69]

Check this........

Shoulder belt issue on 68 Barracuda

I had a member make me a set of seat belt for my 68 Barracuda fastback including shoulder harness belts. Well went to install them and had a oh **** moment. The holes are in the roof line for the belt anchor, but there is no nut welded on the back side! Anyone run across this and have a solution?

www.forabodiesonly.com

a diagram............

Wesco performance seat belts i bought

I bought a nice set of wesco performance seatbelts for my 67 cuda notch. I plan on adding shoulder belts with inertia reel. I ordered them with the chrome lift latch buckle similar to what the stock 67 lap belts would have had. My price shipped for 2 shoulder belts, and 2 rear seat lap belts was...

www.forabodiesonly.com

 

[RedFish]

The bump out in the roof was for the coat hook until 68 model. They moved that hook rearward a few inches to put the belt attach point there. It's right above where the 2 windows meet. Many have to use a long needle to fish for holes at dome lamp, visors, etc.. It's all fun. Leaving bolts and screws in the holes before installing headliner takes away the fun.