Shainesboostin
Well-Known Member
Ok, so on my ballast, there are 3 wires. 2 tit'd together, and 1 that runs to the positive on the coil and is tied into a wire going into the voltage regulator.
I was told to ditch that wire, and the 2 tied together feed the red wire on the msd. But I don't have power at those in the run position, however 1 have power at the single wire.
I was told to ditch that wire, and the 2 tied together feed the red wire on the msd. But I don't have power at those in the run position, however 1 have power at the single wire.
Last edited: