Temp Gauge Wiring Missing

[Austin Schlegel]

Hi,

I am not getting any reading on my dash temp gauge. I think this is due to the missing connector for the temp sensor in the engine bay. I have traced the temp sensor wiring to the disconnected plug shown in the pictures. I cannot find a female connector for this anywhere. Does anyone know where this connects too?

Edit: 1974 dart sport

Thanks,
Austin

 

[krazykuda]

It's a round cap press on connector...

 

[Austin Schlegel]

It's a round cap press on connector...

So I dont see the other end anywhere in the engine bay. Any idea where I can get the other end and where it would go?

 

[Dana67Dart]

Go to myMopar.com and download your years wiring diagram.

Trace out the temp sender wire and find what bulkhead connector it goes through and see if there is a wire there in the engine and cabin side of the bulkhead connector

 

[krazykuda]

So I dont see the other end anywhere in the engine bay. Any idea where I can get the other end and where it would go?

The wire goes along the inside of the pass side valve cover and comes out near the alternator wiring...

 

[cudamark]

It's a round cap press on connector...

Yup, 90 degree black rubber cap and a green wire IIRC.

 

[67Dart273]

Austin, have I talked to you about a service manual?

 

[Dana67Dart]

Wiring – MyMopar

 

[Scamp Rhonda]

The wire goes along the inside of the pass side valve cover and comes out near the alternator wiring...

Exactly, well at least that's how it is for my '72 Scamp.

 

[Dana67Dart]

Violet wire "R" on the bulkhead connector.

 

[townsend]

Could you give us the month and year of manufacture off the driver door decal.