This is my progress on my shift kit installation. My goal is firmer upshift than stock. So I have only drilled the hole in the separator plate like this: A .110" B .086" C .110" D .125". I thought it is easier to make bigger hole than smaller afterward.
In the last picture it shows how to drill out the wall. Will the upshift be to firm if I remove the wall and keep the ball? Or would it be necessary to get some firmer upshift like my goal is? Or will it be enough to just leave the wall and install the other parts in the kit?
Thanks FABO
In the last picture it shows how to drill out the wall. Will the upshift be to firm if I remove the wall and keep the ball? Or would it be necessary to get some firmer upshift like my goal is? Or will it be enough to just leave the wall and install the other parts in the kit?
Thanks FABO