I’ve called three times and was put in the Q over a hr every time and I just hung up. I’ll give it a try again next week. I just don’t understand how you can call summit and tell them what heads you have and they can’t cross reference to find the part you need.
I want the copper or aluminum one so I don’t have to worry about blowing out the header gaskets. I know eventually they will blow out but with the victor heads and it being so tight in a 72 duster I’m just trying to cover my bases and making my life easier with the upkeep on the car. If there is such a thing in a 72 A body car with a 512 Victor headed motor in the engine bay. I’m thinking now I should have built a stroker small block and called it a day!
I’m using TTI 2” headers. Thanks for the info I’ll definitely be giving them a call. Thanks
Thanks for the heads up on the right size gaskets I’ll need. Unfortunately I didn’t get the instructions from my engine builder and he retired right after he finished my engine. And my car and engine has been at friends shop for about 15 months just sitting waiting for him to finish a few projects to get started on it. And he just started on it last week.
Thanks for the part number these are the ones I needed. Much appreciated
I ordered these gaskets and strangely there a tad to small go figure.
What are the measurements of your exhaust ports?
Have you tried Hughs engines ?? All I use , mine is between max and regular CNC victor knock offs...
I’m on vacation and not in town so I can’t measure them at this time. I did place the gaskets last week over the exhaust ports and the ports were significantly larger. I ended up getting the larger ones from Mr Gasket and they fit perfect.
I ended up getting the right ones from Mr Gasket part #7430G they fit perfectly.
