Where can I get cupped pushrods at 7.200"?

-
myasylum

myasylum

Well-Known Member
Joined
Sep 18, 2008
Messages
1,739
Reaction score
6
Location
Las Vegas, NV
I am seeming to have a hard time finding push rods that are cupped at a 7.200 length. Can someone post a link if they know? 7.225 is fine too.
The closest I found was 7.335. Sucks.

Thanks!!
 
what i was gonna say.They have sets you cut to length in case you want a custom set due to different valve heights
 
I'm a big fan of Smith Brothers. It's what I run. (Not sure if that's a good endorsement.)
 

I called Manton and Smith Brothers... Manton was $30.00 cheaper, and took their time explaining a lot to me over the phone.

I haven't bought them yet, but so far Manton does seem better... from my minimum experience so far.
 
Glad you started this post. I will be in need of special length pushrods as soon as I get my checker and figure out what length I need. toolman
 
I didn't even think I'd need a "special" length. It was a surprise to me! It cost more money this way too.

Manton was $150 (Stage 2) Shipped, Smith Brothers was $180.00 shipped. They need to know the Spring pressure and Whether your engine is naturally aspirated or not. So it's best if you know that before you call. I did a lot of... "Ah?? Ahh??? Ahhh??" as I was trying to find the pressure online! lol! I couldn't remember.

There are a couple other places I could call... but I think I decided not too.
 
Terry Manton is a very good guy. I use Manton almost exclusively.

I do have a couple of sets of Smith bros and they are a very good product as well.

Hard to go wrong with either supplier.
 
You must log in or register to reply here.
-
Back
Top Bottom