Search results for query: *

Looking for thoughts on sleeving the yoke pinion shaft for my 742 sure grip differential. Anyone have experience doing this and even better have a part number for the sleeve. Looks simple enough on a utube video, let me know what you think. Thanks!

Just bought a new pinion yoke kit for my 742 diff. I got it on eBay from john wolfe, who sells a lot of Mopar parts. After I installed it and was bolting the u joint in I noticed that one side of the mounting bracket were the u joint sits in was wider than the other, by at least an 1/8 inch. My...

Which is the better pinion seal, leather or rubber? Don't want to go the cheap route and have to replace this again. Is there any difference at all, are there any tricks to make sure that it doesn't leak? Let me know which you like better and why, thanks!!

Looking for best type of pinion seal for 742 rear end, does anyone have a part number. It's the small yoke 10 spline type, thanks!

I have an 8.75, 742, rear differential and want to change the oil. Not leaking so no need to change gasket or seal. What is the best way to drain and how much should I refill, to the lip of the plug?. What is the best oil to use when refilling? Thanks

What type of puller works best for removing the yoke on my 8 3/4 differential? I'm doing this in my garage with the car on jack stands, will a steering wheel puller work? Does Auto Zone loan a puller that works? Trying to avoid buying a puller that I may only use once, let me know and thanks.

I have an 8.75 Sure Grip with a 3.23 gear, that I bought a couple months ago and was told it ran fine, no issues. Well after reading several threads about installing these I've decided to have it gone through before I install it. Can someone recommend a shop or a Mopar guy within a 100 miles (or...

Trying to set up the stock kickdown linkage on my 318 with a 904. How does the lever on the trans work, with the engine off and everything cooled down the lever just moves forward and back, should there be tension on the lever with the engine off?. I hooked up all the linkage and was wondering...

I have a speedo drive gear on my 904 transmission that is not spinning the cable I think it's not set correctly as the hold down bracket was loose. (I also verifid the speedometer is working by using a drill on the cable.) Do I need to drain the transmission fluid to work on this or can I adust...

What is the torque setting for the flex plate to the converter? My book says 270 in-lbs what is that on a 100lb torque wrench? Or better put "What should I torque the flex plate to the torque converter at?". Thanks

Just had my 904 transmission rebuilt with a shift kit and a 2600 stall converter. My 318 is rebuilt putting out 325 HP, I'm looking for trans fluid help. I'm thinking AMSOIL ATF, they also have a Super Shift Race Fluid. Anyone have experience with either brand or a different type. Not planning...