Divenut
Well-Known Member
Hey Folks,
I apologize in advance for my lack of knowledge on the topic. ops:
Finally getting around to fabbing up and welding in some subframe connectors. I have a line on rectangular tubing with the following specs:
3" x 1 1/2" x 11ga hr rect or 3" x 1" x 14ga hr rect tube
I am leaning towards the 3"x1.5" stock which seems like it will clear the floor board w/o cutting, but am wondering if it will slide the over rear frame rail after I notch the top tubing out being 11ga wall thickness?.
Thanks as always,
Pat & Kids
I apologize in advance for my lack of knowledge on the topic. ops:
Finally getting around to fabbing up and welding in some subframe connectors. I have a line on rectangular tubing with the following specs:
3" x 1 1/2" x 11ga hr rect or 3" x 1" x 14ga hr rect tube
I am leaning towards the 3"x1.5" stock which seems like it will clear the floor board w/o cutting, but am wondering if it will slide the over rear frame rail after I notch the top tubing out being 11ga wall thickness?.
Thanks as always,
Pat & Kids