As long as it goes all the way in not in a fitting that will keep it out of the wp housing tried that with a t it gets cooler.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
I had to put the fan sensor in a rad hose fitting , works good though.
Here's a X block W2 headed 349 cube small block in a 4500# truck. The thing screams!
The bosses with the plugs to drain the water out of the side of the block work also. I just could not use them with the headers.
MomsDuster
Well-Known Member
MomsDuster
Well-Known Member
I like that idea! Going to look into that!
The pipe plugs on the side. I usually put petcocks in them to drain the crap out once a year. Will give a true temp of the engine water jackets.
K. Yup. I need that motor...
Yum!
Unconventional
Well-Known Member
I was thinking after I looked again, That looks like the back of my '72, and that front bumper without bumperettes would be a fine improvement also
Ddaddy
I'm changing the World... one pixel at a time!
Ddaddy
I'm changing the World... one pixel at a time!
Just having a couple before I get busy cleaning the bunch of fish I caught today. Don’t want to have too many before handling razor sharp fillet knife!
mudleruckin robbery I say!
Only needed 1, so I got it. Just the 2 tailgate panels on he Magnum have total of 16 of these. Then there is 4 of another style for the piece on the window where the 3rd brake light mounts.I broke 2 and ordered a 10 pack from clips and fasteners for $15 shipped.
Only needed 1, so I got it. Just the 2 tailgate panels on he Magnum have total of 16 of these. Then there is 4 of another style for the piece on the window where the 3rd brake light mounts.I broke 2 and ordered a 10 pack from clips and fasteners for $15 shipped.
Had to share this to funny
Next time go here I know I posted it before they are great
Auto Fastco / A division of The Fastener Warehouse
Auto Fastco / A division of The Fastener Warehouse
Ddaddy
I'm changing the World... one pixel at a time!
Better than Auto Fiasco / a division of WTF Industries...
Got the 20 clips I needed through them for 12, way better than 8 each!
Barb found that site.
will check later to see if they have them. Not the first time I pulled that panel and probably not the last. plus I think some of the other panels use them. It actually comes up as a Jeep door panel fastener
If it is not on the site call them with the part number. They only have a bit of what they sell listed.
Fasteners are definitely a rip off. Body shop suppliers have the commo ones in stock also way less than that, needed some other style and think they were thirty cents each instead of 3.00!
Mark I think I was looking at a thermostat housing that had a bung on it also. Been a while,
-
