Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Good Morning All! First cup for me. I managed to sleep in until 4:30 then son called from Iceland, just landed for his study abroad.
MomsDuster
Well-Known Member
Good morning
Rain yesterday here, glad we finally got our awning replaced. Hated paying a deductible but saved quite a bit on replacement cost. Already put tie downs on this one but will make sure I retract it (manual) if the wind picks up. Sunny and warmer today, might get to 65 dunno.
have a couple more cups and you will shake enough that you won't notice it in the car.
You made me have a flash back, saw the coffee maker AND the 5 gallon olive drab can of coffee with the NSN on it : )
MomsDuster
Well-Known Member
I like your style!have a couple more cups and you will shake enough that you won't notice it in the car.
Ya we’re in Nebraska. Think the nearest Navy Inn might be Great Lakes Training Center?? All I say is hurry up Cheryl!!
- Joined
- Mar 17, 2018
- Messages
- 13,425
- Reaction score
- 30,567
When are you heading to the show? I am still at hotel nursing a slight dehydration issue! Teach me to travel without the wife!
MomsDuster
Well-Known Member
Throwing a couple of thoughts out to get y’alls opinion,
1: found a melted plug wire, could that have been the smell I was getting? Can’t say I’ve ever smelled a plug wire burn?
2: excessive play in steering box cause the shake I’m experiencing?
Just throwing it out there.
1: found a melted plug wire, could that have been the smell I was getting? Can’t say I’ve ever smelled a plug wire burn?
2: excessive play in steering box cause the shake I’m experiencing?
Just throwing it out there.
- Joined
- Mar 17, 2018
- Messages
- 13,425
- Reaction score
- 30,567
I am leaving hotel now. See ya in a bit
Water, you have to drink water.
1: Yes
2: Yes
Good morning. Supposed to rain all weekend here. Need to work on the camper, 1972 Winnebago tandem axle travel trailer. Black and gray water drains needed new gate valves and a bit of support in the floor above it.
Bad news, my hard drive can't be saved. Good news so far, I only have 4 months of photos unaccounted for. I am hopeful they got saved on my wife's laptop.
MomsDuster
Well-Known Member
I replaced drivers side header gasket the night before all this went dow, must have screwed the pooch when putting the wire back on and just neglected to pay proper attention to the position. Doubt that was the shake. 1) my luck doesn’t run like that, and 2) it wasn’t a miss. She was running good. This was definitely front end. Thinking even like Frank mentioned possibly brake induced. Was also noticing like a brake drag in gear at an idle. Going to look at brake system also just for piece of mind. Oh and not a fan of plain vanilla shakes. More of a full blown chocolate malt guy!
I replaced drivers side header gasket the night before all this went dow, must have screwed the pooch when putting the wire back on and just neglected to pay proper attention to the position. Doubt that was the shake. 1) my luck doesn’t run like that, and 2) it wasn’t a miss. She was running good. This was definitely front end. Thinking even like Frank mentioned possibly brake induced. Was also noticing like a brake drag in gear at an idle. Going to look at brake system also just for piece of mind. Oh and not a fan of plain vanilla shakes. More of a full blown chocolate malt guy!
Chocolate Marshmallow!
Just got back slim pickings this year. Got a few metal snippers and a inch pound beam style torque wrench. $3 for it all!
Inch pound beam. Perfect for rolling torque on pinion bearings and lawn mower cylinder heads. LOL
Pinion bearings and for the side play on a 8.25!
-
