Recent content by 38 Dodge

I wanted to let you know about my swap. I got this motor, the push button transmission, along with the motor mounts, center link, and exhaust manifold. I know the heater box has to come out and I might have to modify the top of the fire wall for the distributor. I will also be replace the front...

Here are some pictures I just took not sure what I’m looking for on the crank and it’s hard to look with it on the engine stand. Also a picture of the tag on the front of the motor.

Ok went out and looked in thru the spark plug holes and with my boroscope I only see two valve relieves. I will go back out and check the crank as listed above. planing on using a push button auto behind this motor.

Thanks Hyper, Been gone for a little while life happened and now I’m getting some time back.

Thanks but this motor has adjustable rockers, but would / could this be a commando motor how would I be able to tell?

Let me start with I just need a running motor to put in my 62 Valiant Wagon. And I just acquired a 273 motor which has a factory replacement tag from 69. But it has the 64/65 heads. is there anything special this block / head combo

Will do sorry I’m still trying figure my way around this site.

Found and thank you moparfan68

Thank you so much Thanks again

In need of a 273 Pushrod for a solid adjustable rockers. 7.5 X 5/16

Here is a picture of them

No worries I’m looking to get rich and they won’t be any use to me. but I will let you know when I take them off hopefully when this winter storm stuff gets over soon.

No worries I have a lot of / 6items will be going up. Also if your interested I also have a dual carb intake

I have a set on my 62 valiant that I’m fixing to pull out. If you are still looking when o get the pulled they will be available along with lots of other /6 items.

How will this fit on my 64-65 273 if it has been drilled? Would I need inserts or just a large washer over the bolt holes?