Recent content by Austin Schlegel

So I dont see the other end anywhere in the engine bay. Any idea where I can get the other end and where it would go?

Hi, I am not getting any reading on my dash temp gauge. I think this is due to the missing connector for the temp sensor in the engine bay. I have traced the temp sensor wiring to the disconnected plug shown in the pictures. I cannot find a female connector for this anywhere. Does anyone know...

Hi, I am mounting my 904 transmission up to the ole 318 and have found that the flex plate is not mounting directly up to the torque converter. If you look at the pictures you can see that there is about a 1/4" space between the fp and tc. I dont want to bolt them up because im afraid that that...

Hi, The core plug in the back of my passenger side cylinder head has popped out. It was one of those rubber plugs that you can expand with a wrench. I would like to replace it with the proper brass plug. The engine is a 1974 Dart sport 360. I am struggling to find the correct plug size. Does...

I have a spring from another 904 that I am going to place in it

Hi, I am in the process of putting back together my 1968 904. In most videos I see there is a spring for the circled servo in my pic: When I removed my vavle body I do not remember seeing a spring there. Does anyone know if I need a spring for 1968 trans? Thanks

I will do some research on this and get back to you

Hi, I am looking for a replacement front oil pump gear for my 1968 904 trans. The gear I need is shown in the pictures. Does anyone have one or know where I can get one that isn't too expensive? Thanks

I am running a 318 and 904, I dont think I will be pushing that high of power

Hi, I am installing the rear end back in my 68 barracuda but am missing the support piece that is shown in the diagram here: Do I need this and can someone point me in the right direction to find one? thanks

Can you explain what you mean by 56 degrees? And what proper parts are you referring too?

I still agree that I should get the proper linkdown parts for this carb though. Which I will look into getting over the winter.

I think I have fixed the issue. I added another quart of fluid to the transmission and it appears to be driving fine. I havent had a chance to drive it extensively though due to the cold weather and salt on the roads. Will find out when the weather gets a little warmer and post on this thread...

The car came with a lokar kickdown cable. Would I be better of installing that you think?

I will check the trans fluid today after work It was doing the same thing before the fluid change. I am barely pressing the peddle and it will shift down. Not sure what the gearing is but I know it has 7 1/4 rear end