Recent content by berry-cuda

Thanks for the ideas guys I have the fuel lines ran up to the engine bay just gotta figure out which is best next, I want to use majority hard line but my tubing bender won’t do nice 90deg bends might have to look into a new one

Installed a sniper on my small block and was wondering what you guys running them did with the fuel lines to make them have a fairly clean look? Thanks

Any idea how many amp the factory one is rated for?

I guess I could just hide the stock one, as for bumping it to set lash I have a hand trigger I use that goes to the starter solenoid lol

Has anyone got rid of their old style starter relay and installed a more modern one that’s hidden? Basically wiring my car from scratch and wanting to get rid of the old style as they are not very appealing to the eye, any cons to doing this? Tia

It’s was laying down on top of The sleeve spacer, I’ll do s double Check and make sure I got 19 in all them

Ok so it was really bugging me so I ran out to the garage and it was a roller fallen over, it seems that I got one extra one in the kit and it had gone in and fallen over, I guess I should have checked before I asked lol thanks again for the help

Yeah the center is just the arbor I will pull it apart and make sure No rollers fell over but I’m almost positive it didn’t, there are 4 spacers total 1 on each outside and one between each set of needles, all the spacers are the same thickness, tomorrow I’ll pull it all apart and see to make sure

so I’m in the process of putting in my hemi OD kit from Passon Performance and am having troubles with the gear cluster fitting. I have all the spacers and needle bearings and and the last spacer sits proud of the end making it to long for it to fit in with the thrust washers should the spacers...

Yeah I cut the equinox one and drilled out the splines a bit where I welded it

I emailed Pypes and they will only sell the complete kit, and wont mix and match with a 3” x pipe. Which kinda sucks. I know I could just go 2.5” the whole way but it’s a certain sound I want to achieve not HP related, as I’ll only be putting out around 425hp

Nothing leading up to them yet but wanting to do a 3” x pipe and mufflers and then drop it down to 2 1/2” tailpipes

Where do I get just the tailpipes from I only seen full systems

So i have been looking for some 2.5” tailpipes for my duster preferably stainless I see some people are running Flowmaster tailpipes and they seem to be a good price for B bodies but I can’t find just the pipes for an A body, anyone know of the part number or any other good stainless tailpipes? Tia

Looking at the one thread it looks like the Nissan Versa is almost identical to the equinox one I used but has the remote ecu, you could probably install that one very similar to the way I did mine with little to no changes If I where to do it again I would probably try that one.