I can relate to this thread. There are some weeks I can't get motivated and other weeks I'm on it like white on rice. Working out of a car port sucks because anything you take out you have to put back, so working on the car after work you have to be selective on what you want to do and save you...
Been poking the same hole for over 30 years now. Our key to a good married life is being truthful about everything even if you don't like what you hear. My wife likes old cars but not the shows. She would rather drive them than show them. She has never given me any type of resistance when it...
Do these control arms will work with the 73 and up stock disc spindles or do I have to use your spindles in order for these to work?
The majority of the disc conversion kits out there require for you to use their upper control arms with their spindles.
The housings are the same, but I guess the internals are different. I thought I could catch a break by using the complete O/D housing and do the swap with a 46RH 4x4 trans. I was also pondering about using the pcm from the dakota and integrating the transmission signals with the cheby tbi PCM I...
I found a rebuilt 46 RE 2wd trans for a mock up for my 65 Barracuda. I already know all of the fabrication that has to be done on the tunnel.
My question is: Will the o/d housing from the 46 RE fit on either a 42 RH or a 46 RH 4x4 housing and will it work?
Thanks in advance
Mike
Not to steal the thread but back to the tank. I found one at tank inc, just like the one pictured from Rock Valley. I ordered the tank, pump and insert for a bit over 400.
Sorry for the interuption. Now back to the build.